The surface temperature should range from 59 to 90 degrees F (15 to 30 ℃) to achieve the best results. If the surface is hot to the touch it’s probably over 90 degrees Fahrenheit. Adhesive becomes brittle when it gets too cold and gummy when it gets too hot. Applications outside the suggested range of 59 to 90 degrees Fahrenheit decrease the ability of the adhesive to perform.
Outdoor application is discouraged but can be done when winds are less than 10 mph. Blown dirt, dust or other contaminates can interface with the bonding of the graphic adhesive to the vehicle during installation.
Wash the surface with the solution of dish soap and warm water then rinse with water. Dry the area with a clean, lint-free cloth or paper towel. Wipe down the entire area again with Isopropyl Alcohol to remove any contaminants and promote the adhesion process. Dry the surface a final time with a fresh lint-free cloth or paper towel.
A few drops of dish soap in warm water
Clean, dry, lint-free cloth or paper towels
Isopropyl Alcohol (if available)
Determine the location where you want the vinyl N transfer to go. Use a tape measure and a pencil to help center the item in the space available. Secure each end or corner with a piece of masking tape.
Masking tape
Tape measure and pencil
Apply strips of masking tape vertically to the center of the vinyl transfer, over the premask. This creates a hinge allowing the graphic to be applied one section at a time.
Masking tape
Remove the positioning tape from one end of the vinyl transfer and hold down the release liner while slowly peeling the premask away back towards the hinge. The vinyl will remain on the premask. Temporarily tape the peeled section to the surface and cut away the release liner with a knife or scissor.
A few drops of dish soap in warm water
Application squeegee
Hold the vinyl transfer by| the premask and do not touch the adhesive side of the vinyl to the surface until you are ready to squeegee. Hold the end of the vinyl transfer several inches away from the surface and starting at the center hinge, slowly make easy, overlapping vertical strokes with the squeegee. The slower you go, the less bubbles you will get. Now, remove the tape hinge and peel away the release liner on the other side of the vinyl transfer. Apply this section the same way as the other.
Application squeegee
Wait up to 30 minutes to remove the premask if you used the wet method. Starting from a comer, slowly peel away the premask directly across itself at a 180 degree angle. Carefully re – squeegee any areas that seem to lift. After the premask is off, cover the squeegee with a sock or paper towel and go over the vinyl again, especially around the edges. Examine the vinyl for bubbles and prick them with a pin and squeegee the air out towards the puncture. A heat gun or hair dryer will assist in the removal of bubbles
Clean, dry, lint-free cloth or paper towels
Hair dryer or heat gun (optional)
Application squeegee
Order Your custom decal
It’s simple really, upload your logo, tell us how big you need it and we do the rest. We can also help you install it through video tutorials or in person if we’re within driving distance. We use weather resistant vinyl that lasts for years.
ORDER NOW